Mini Lathe Amateur, Episode 3

2개월 전

Hello, steemies!

It's time for another episode of mini lathe amateur!

For this week's episode, I talk about attempting to set up my new lathe faceplate to be able to hold larger pieces than the 3 inch chuck can hold. I tried to set the faceplate up with an adapter that could be held in the outside jaws of the chuck, but I ran into a problem with one of the outside jaws not fitting properly in the chuck when I swapped out the inside jaws for the outside jaws. After I got that problem sort of worked out, I ended up having too much runout on the faceplate with the adapter held in the ill fitting outside jaws of the chuck.

Thanks for stopping by to check out my video!

steeming on.jpg

Authors get paid when people like you upvote their post.
If you enjoyed what you read here, create your account today and start earning FREE STEEM!
STEEMKR.COM IS SPONSORED BY
ADVERTISEMENT